The cylinder should be used in compliance with relevant safety regulations. When a failure occurs, there should be an emergency stop device. After the work is completed, the compressed air inside the cylinder should be discharged.

Cylinder maintenance and maintenance methods:

1. When the cylinder is inspected and reassembled, the parts must be cleaned, especially to prevent the sealing ring from being cut or damaged, and pay attention to the installation direction of the dynamic sealing ring.

2. During use, you should regularly check whether there are any abnormalities in various parts of the cylinder, whether the connection parts are loose, etc. The movable parts of the cylinder installed with a pin type should be lubricated regularly.

3. When the cylinder is not used for a long time, all processed surfaces should be coated with anti-rust oil, and the inlet and exhaust ports should be blocked with dust.

4. When the cylinder is inspected and reassembled, the parts must be cleaned and dirt must not be brought into the cylinder. In particular, it is necessary to prevent the sealing ring from being cut or damaged and pay attention to the installation direction of the dynamic sealing ring.

5. Develop a monthly, quarterly and annual maintenance system for the cylinder.

When the cylinder is working, the piston will hit the cylinder head, and the buffer seal ring of the cylinder head is a wearing part. If the buffer seal ring is seriously damaged, the buffer plunger and the buffer seal ring will not be well sealed before the end of the cylinder's stroke. thereby losing the buffering effect. When the cylinder is used for a long time, the sealing ring usually needs to be replaced and lubricated at the same time.